Violating the E82 Coupe's wing mirrors

[EvestineBeetle]

The tremor in the passenger wing mirror has just recently been noticeable.
The door controls work as intended, and I looked on the driver's side for any differences; I didn't find any, so I'm assuming the damage is on the backing plate or gasket.


I haven't looked closely, but maybe I can figure it out if there's a screw hidden beneath a plastic cover.

I should probably wait till I won't have to drive for a few days just in case I exacerbate the situation.

Should I wait to try till I have some waterproof double-sided tape?

Is there a chance that the glass may come out at some point? Perhaps I should secure it with tape before it happens.

Watching a few tutorial videos on YouTube to have a feel for it all.

So I could see if it required clipping back in, I carefully pushed the mirror around the borders.
There was a lot of motion, which could be considered typical. The driver's side looked identical.

Is there anything more you would recommend at this time?

Always appreciate your assistance.

Edit:

Rechecking has shown that, unlike with the Drivers, I can push the top of the mirror and the bottom will protrude further.
I could probably take it off with a little effort, but I'm not going to do that right now.

My vision isn't ideal, but I can see a cover beneath; nevertheless, I can't see any openings to remove it.
Unless the entire thing needs to be taken off, I fail to see how I could reach behind the glass in that manner.

[Noble4u]

To ensure appropriate adherence to the backing plate, just pop out the mirror—a task that is quite easy to accomplish. As you explain, if it comes undone on one side, all you have to do is use some strong double-sided tape. Replacement mirrors are more expensive, but this remedy will save you money.

I also experienced something similar, and the tape helped. So far (after around six months), it has been solid, and I will not replace it until it falls out completely.

[EvestineBeetle]

Much obliged,
Asking if you should use a trim tool to carefully take it out from the largest opening or from all sides, I'm not sure I understand.
What are the odds of it malfunctioning?

[Noble4u]

I would recommend a trim tool or something like. Expand the space on one side by repositioning the glass as far away as possible; then, using a combination of your fingers and the pry tool, pop the clips that are keeping it in place. As the mirror rests on a plastic base plate, these mirrors are more than just a pretty face. Before prying, double-check that you're behind both layers—not just the glass, since that may easily come free. Simple, and if you still have questions, you may view this video.

[Noble4u]

After that, disconnect the heating cables and begin applying the double-sided tape. In order to insert the tape, gently separate the glass from its surrounding surface if it is lifting on one side or edge. While positioning, keep one side of the protective layer on. Once it's in place, use tweezers to carefully remove the remaining layer, leaving a small gap. Then, push the two halves together firmly.

[Noble4u]

https://www.youtube.com/watch?v=j5hPZXnXEMc

[EvestineBeetle]

Much obliged for the data, however

I doubt I have heated mirrors unless you count the wiring.


I am unable to access the link. produces a mistake

[Noble4u]

I modified the URL, strangely enough -

[Noble4u]

https://www.youtube.com/watch?v=j5hPZXnXEMc

[EvestineBeetle]

Appreciate it! The link is functional.